Iveco — 603.93.641-3Cp

216 F3B ENGINE T RAKKER E URO 4/5 540850 ENGINE FLYWHEEL  Fitting engine flywheel Figure 190 VIEW OF HOLES: VIEW OF HOLES: A - B - C D DETAIL OF PUNCH MARKS ON ENGINE FLYWHEEL FOR PISTON POSITIONS A. Hole on flywheel with one reference mark, corresponding to the TDC of pistons 3-4. - B. Hole on flywheel with one reference mark, corresponding to the TDC of pistons 1-6. - C. Hole on flywheel with one reference mark, corresponding 60668 to the TDC of pistons 2-5. - D. Hole on flywheel with two reference marks, position corresponding to 54 . NOTE If the teeth of the ring gear mounted on the engine flywheel, for starting the engine, are very damaged, replace the ring gear.

It must be fitted after heating the ring gear to a temperature of approx. 200 Figure 192 C. Figure 191 49036 Second phase:closing to angleof 90 with tool 99395216(1). 49037 NOTE The crankshaft has a locating peg that has tocouple with the relevant seat on the engine flywheel. Position the flywheel (1) on the crankshaft, lubricate the thread of the screws (2) with engine oil and screw them down. Lock rotation with tool 99360351 (3). Lock the screws (2) in three phases. First phase: pre-tightening with torque wrench (4) to a torque of 120 Nm (12 kgm). Base q November 2006 Print 603.93.641