SECTION 2 MAINTENANCE Page 10 Apply grease to the grease fittings shown by arrows. LUBRICATING 1. Rear axle pivot pin (2 points) if the air conditioner has been used, the air filter - should be cleaned. AIR CONDITIONER FILTER i Stop the air conditioner before cleaning the element. 1. Move the operator’s seat forward, then tilt the backrest forward. 2. 3. Loosen screw (2) and cover (1) holding the filter element, pull out element (3) and clean it. Loosen the bolts and remove the cover. 4. After cleaning the element, align it with the direction shown by the arrow, and install.
* Direct dry compressed air (less than 7 kg/cm2) to element from inside along its folds, then direct it from outside along its folds and again from inside, and check element. WARNINGI When using compressed air, wear glasses and other things required to maintain safety.