Ignition System/Ignition Coil 8. Be sure coil lead wire is in notch in the base; then install breaker point cover. Tighten cover set screw snug only so cover is not crushed or deformed. 9. Install air cleaner assembly. (See Install Air Cleaner in Group 05 in this manual.) M37242 -UN-25JAN90 M98,2065K,4 -19-05NOV85 REPLACE IGNITION COIL—B43E, B43G, B48G, AND T260 ENGINES 1. Remove air cleaner assembly. (See Remove Air Cleaner in Group 05 in this manual.) M37156 -UN-25JAN90 M37157 -UN-25JAN90 2. Disconnect spark plug wires (A). 3. Loosen screw (B) to remove coil. 4. Remove wires (C) and (D). 5.
To install coil, fasten breaker point lead to negative (-) T260 Engine (Top Photo) terminal (D) and ignition switch lead to positive (+) terminal (C). 6. Install coil and fasten with screw clamp (B). 7. Connect spark plug wires (A). 8. Install air cleaner assembly. (See Install Air Cleaner in Group 05 in this manual.) B43E, B43G, B48G Engine (Bottom M98,2065K,5 -19-11FEB87 65 2 CTM2 (19APR90) 65-2 16, 18, 20 & 24HP Onan Engines AllTractorManuals.com 130495