Cooling System/Water Pump (standard model) WATER PUMP BEARING SHAFT INSTALLATION 1. Use JD-262A or JDE74 Bearing Driver to install bearing shaft. 2. Press into housing until bearing face is flush with housing hub face. CD7360 -UN-23FEB89 CD,3274,G30,8 -19-07APR92 CTM3274 (01JUL99) 30-14 Saran Liter Engines 060799 PN=213 WATER PUMP SEAL INSTALLATION NOTE: The unitized (one-piece) water seal (A) has replaced the previous three-piece water seal (B). The unitized seal is to be used even if the -UN-21AUG92 three-piece seal is still included in repair kit. In this case, order also AR101549 water pump seal kit. 1.
Place pump housing under a press so that the thrust RG6389 when pressing on seal is received only by the pump shaft face. IMPORTANT: Installation tool (C) MUST be used to drive seal into pump housing. This tool exerts the correct pressure on seal faces. Do not use sealant on any portion of seal. -UN-03FEB95 2. Using special tool (C) included in repair kit, install water pump seal (A) simultaneously over shaft and into housing until seal bottoms on shoulder of housing (D). RG6376 CD,3274,G30,9 -19-01FEB94 30 14