John Deere 450DLC — Replace DEUTSCH™ Rectangular or Triangular Connectors

References IMPORTANT: Install contact in proper location using correct size grommet. 6. Push contact straight into connector body until positive stop is felt. 7. Pull on wire slightly to be certain contact is locked in place. TS122 –UN–23AUG88 8. Transfer remaining wires to correct terminal in new connector. LD30992,000023D –19–31MAR06–2/2 TM2361 (24JUN08) 9015-20-119 450DLC Excavator Operation and Tests 062608 PN=609 Replace DEUTSCH Rectangular or Triangular Connectors NOTE: Connector shown is the female half or a 4-pin square connector. Other similar styles of Deutsch connectors can be serviced using the same –UN–01MAY00 procedure. 1. Pull connector (1) apart.

Inspect and clean connector seal and contacts. T130688B 2. Remove locking wedge (2) from connector using hook on JDG1383 service tool. 1—Connector 2—Locking Wedge DEUTSCH is a trademark of Deutsch Co. Continued on next page LD30992,000023E –19–31MAR06–1/2 9015 20 ,119