cisco — Configuring Persistence with Auto-LAG

Procedure Configuring Persistence with Auto-LAG You use the persistence command to convert the auto created EtherChannel into a manual one and allow you to add configuration on the existing EtherChannel. To configure persistence with Auto-LAG, perform this procedure: Procedure Configuring EtherChannels Configuring Persistence with Auto-LAG Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 interface interface-id Example:

Device(config)# interface gigabitethernet 1/0/1 Specifies the port interface to be enabled for auto-LAG, and enters interface configuration mode. Step 4 [no] channel-group auto Example: Device(config-if)# channel-group auto (Optional) Enables auto-LAG feature on individual port interface. Use the no form of this command to disable the auto-LAG feature on individual port interface. Note By default, the auto-LAG feature is enabled on the port. Step 5 end Example: Device(config-if)# end Returns to privileged EXEC mode. Step 6 show etherchannel auto Example: Device# show etherchannel auto Displays that EtherChannel is created automatically. Command or Action Purpose Step 1 enable Example:

Enables privileged EXEC mode. Enter your password if prompted. Configuring EtherChannels 29