Configuring DSCP Marking on a RADIUS Server Follow these steps to configure DSCP marking for authentication and accounting on a radius server: Procedure Configuring RADIUS Configuring DSCP Marking on a RADIUS Server Command or Action Purpose Step 3 radius server server name Example: Device(config)# radius server rsim Specifies the name for the RADIUS server configuration for Protected Access Credential (PAC) provisioning, and enters RADIUS server configuration mode. Step 4 address { ipv4 | ipv6 } ip address Example: Device(config-radius-server)# address ipv4 172.24.25.10 (Optional) Specifies the IP address of the RADIUS server. Step 5 non-standard Example:
Device(config-radius-server)# non-standard Identifies that the RADIUS server using a vendor-proprietary implementation of RADIUS. Step 6 key string Example: Device(config-radius-server)# key rad123 Specifies the shared secret text string used between the device and the vendor-proprietary RADIUS server. The device and the RADIUS server use this text string to encrypt passwords and exchange responses. Step 7 end Example: Device(config-radius-server)# end Exits RADIUS server mode and enters privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Step 2 configure terminal Example:
Device# configure terminal Enters global configuration mode. Step 3 radius server server name _ Example: Device(config)# radius server rsim Specifies the name for the RADIUS server configuration for Protected Access Credential (PAC) provisioning, and enters RADIUS server configuration mode. Configuring RADIUS 34