Appendix Fanfold Continuous Paper (Black Mark) Paper width Black mark width Paper feed direction Cut position Black mark length Black mark Black mark interval 0.5 mm (0.02 inches) or more Perforation Cut Uncut Paper Black mark center position • Auto cutting on the perforation lines will generate scraps of paper that may cause problems. Also, auto cutting ahead of the perforation line may cause problems when feeding paper. Therefore, perform auto cutting when paper is fed at least 0.5 to 1 mm (0.02 to 0.04 inches) away from the perforation line.
• Since the black mark detector is not located at the center of the paper width, black marks on both sides can be detected no matter which edge of the paper is printed from. 362 ter of paper width Item Specifications Paper Type Plain paper, Matte paper, Glossy paper Paper width 50 to 108 mm (1.97 to 4.25 inches) Black mark position See the above figure.
At least 0.5 mm (0.02 inches) away from the perforation Black mark width 13 mm (0.51 inches) or more Black mark length At least 4 mm (0.16 inches), With 4 mm (0.16 inches) or more of space around the mark Black mark center position 8.5 +/- 1 mm (0.33 +/- 0.04 inches) Black mark interval 8 to 304.8 mm (0.31 to 12.00 inches) Paper thickness 0.119 to 0.131 mm (0.0047 to 0.0052 inches) Perforation interval 152.4 to 304.8 mm (6.00 to 12.00 inches) Number of folds 500 or less Perforation form 3 to 5 mm (0.12 to 0.20 inches) of slit length with 1 mm (0.04 inches) interval * There should be no slits at both side edges of paper Holes and cutouts Paper with holes or cutouts cannot be used