— AMCP 706-286 — Engineering Design Handbook (1963)

fQ Downloaded from https://www.everyspec.com STRUCTUPES fluid material into the boundary layer, and material must be porous in order to allow k-' in the large heat required 1or sublimation. the passage of the fluid through its thiclnes. It is also reported that uneven heating or The structural material may be manufac- local hot spots are absent Moreover there is tured by powder meta.u-y technq a built-in stability in the system; local high constructed by compressing layers of screens heating increases the sublimation rate at that to the desired thickness. The fluid may be location, thus affecting a reduction in- heat either a gas or a liquid, but probably a liquid transfer.

A possible defect in this approach coolant would be preferable in order to take exists in connection with the use of low heat advantage of the large heat absorption asao- of sublimation materials which may blow so ciated with the phtse change and the de- much material that the characteristics of the creased container requirements. There are a boundary layer could be altered. This could number of interesting features associated lead to large scale turbulence phenomena with this method of cooling a structure. it with attendant higher heating rates.

It has appears that blowing through the boundary also been reported that burning accompany- layer reduces the magnitude of the heat inkf sublimati-o d,-o rno-t seem t;. be a serious t-A nrsfer ccefficiert which is. of course, de- matter. sirable. There is also a built-in stability in Another method for protecting the struc- the system inasmuch as a local hot spot will ture consists of the application of surface evaporate more fluid at that point.

'Under coatings which maximize the radiation of these conditions, more heat is absorbed at the heat Materials such as cerium having high location in question anzd the net effect is a radiant emissivity characteristics may be tendency to make the thermal inputs more utilized for this purpose. uniforra over the surface of the missile. Structures employing a combination of cool- 4-3.3. Cooled Structures. Under certain con- ing and insulation techniques are also fea- ditions of the missile mission and expected sible, thermal environment, a cooled structure may be necessary or desirable. It appears desir- 4-4.

DESIGN FOR APPLIED LOADS able to consider direct cooling of the primary structure for small missiles where space is Design for the transmission of the applied not available for insulation or for very short loads requires a careful study of critical load- flight times. ing conditions, material properties and struc- Cooling of the primary structure may be tural configurations. In order to enable the accomplished by an internal cooling system structural designer to predict required hard- or by porous coolirPg.

In the internal cooling ware cross-sectional areas, there must also be system, a fluid is circulated through the available a rational set of structural design structure to effect a transfer of heat from criteria. Where there exists a long history the structural material to the fluid. The of experience with a particular type of struc- coolant may be circulated in channels which ture and its environment, adequate design are an integral part of the structure or other- criteria have been established. Unfortun- wise in separate ducts which are in intimate ately, this is not the case in the missile field. contact with the structure.

For long range The experience accumulated thus far is rela- missiles or where there is a re-entry problem, tively limited, and a great deal of complica- it appears that the high heat capacity of the tion has been introduced by the dependence low atomic number metals is an attractive of the design criteria on both temperature property. These metals would be used in the and time. molten state. Some of the undesirdable char- While details of the considerations in- acteristics mentioned have been their poor volved in obtaining design loads, factors of thermal conductivities and difficulties of fab- safety, and allowable stresses and deforma- rication and handling.

tions will not be discussed, the more care- In a porous cooling solution, the structural fully these items are selected, the more effi- ( 62