Chapter 22 G-Code Editor and E-CAM Editor Use the add tappet point icon on the toolbar or right-click on the diagram to choose add a tappet point (see below). Each key point data in the planning section allows users to setup a CAM curve section. Then, several rows of key points data form the CAM curve and all the created key points data forms a E-CAM cycle. For each key point data, users can input the master and slave axis relations. The descriptions are shown below. 22-15 Name Function Description AS AHxxEMC DVPxxMC Key Point Record E-CAM motion Max.721 Max.40 Max.40 CAM Curve Const Speed di t Constant speed V CAM Curve Const Acc. Constant acceleration V CAM Curve Single Hypot.
Single Hypothesis V CAM Curve Cycloid Cycloid V CAM Curve Polynomial Polynomial V V V CAM Curve B-Spline B- Spline V Resolution Used data points of the current section. Auto-configuration Max. 2047 Auto-configuration