L-6534VW Operation Guide Various Print Settings N Press Print . O On the screen displayed, enter the number of copies, and then press Print . Start printing the color plate. Procedure for white plate printing Follow the print procedure for color plate printing. A Set additional printing for white plate in a preset suitable to the type of substrate loaded, and set it as the default preset. U “Necessary settings for white plate printing” on page 176 U “Creating and Editing Print Info.” on page 89 U “Creating and Editing Preset for Printing” on page 91 B Set the output to 2,000 W on the control panel of the corona treater. Note:
When printing the white plate of reverse white printing, we recommend performing corona processing to reduce the outbreak of pinhole wrinkles. C Check that the press switch is set to the Standby position. D Perform printing from the print software, and then check that the print data for white plate was received on the touch panel. E Select the print job from the Job Management menu, and then press Print Settings . F Set the following, and then press OK . G Remove the substrate on which the color plate was printed, and load on the unwinder side.
U “Replacing the Unwinder Side Substrate” on page 99 U “Replacing the Rewinder Side Substrate” on page 115 H Align the eye mark sensor with the eye mark at the point where printing starts. U “Setting Eye Marks and Eye Mark Sensor” on page 125 I Press Adjust Print Position on the Loaded Substrate tab, and then set Adjust Print Position Horizontally and Adjust Print Position Vertically to 0. 178 Item Set value Copies 1 Perform Eye Mark Verification Printing Select