CISPR 35:2016 BS EN 55035:2017 IEC 61000-4-5:2005, Electromagnetic compatibility (EMC) — Part 4-5: Testing and measurement techniques — Surge immunity test 5) IEC 61000-4-6:2008, Electromagnetic compatibility (EMC) — Part 4-6: Testing and measurement techniques — Immunity to conducted disturbances, induced by radio-frequency fields 6) IEC 61000-4-8:2009, Electromagnetic compatibility (EMC) — Part 4-8: Testing and measurement techniques — Power frequency magnetic field immunity test IEC 61000-4-11:2004, Electromagnetic compatibility (EMC) — Part 4-11: Testing and measurement techniques — Voltage dips, short interruptions and voltage variations immunity tests IEC 61000-4-20:
2010, Electromagnetic compatibility (EMC) — Part 4-20: Testing and measurement techniques — Emission and immunity testing in transverse electromagnetic (TEM) waveguides IEC 61000-4-21:2011, Electromagnetic compatibility (EMC) — Part 4-21: Testing and measurement techniques — Reverberation chamber test methods ISO 9241-3:1992, Ergonomic requirements for office work with visual display terminals (VDTs) — Part 3: Visual display requirements IEEE Standard 802.3, IEEE Standard for Ethernet, Section Three 3 Terms, definitions and abbreviations 3.1 Terms and definitions For the purposes of this document, the following terms and definitions apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses: IEC Electropedia: available at http://www.electropedia.org/ • ISO Online browsing platform: available at http://www.iso.org/obp NOTE Terms and definitions related to EMC and to relevant phenomena are given in IEC 60050-161. Attention is drawn to the fact that a common set of definitions has been written for both CISPR 32 and CISPR 35. It is noted that some terms and definitions will only be used in one of these two documents but for purposes of consistency they are intentionally included in both. 3.1.1 AC mains power port port used to connect to the mains supply network Note 1 to entry:
Equipment with a DC power port which is powered by a dedicated AC/DC power converter is defined as AC mains powered equipment. 3.1.2 analogue/digital data port signal/control port ( 3.1.32 ) , antenna port ( 3.1.3 ) , wired network port ( 3.1.34 ) , broadcast receiver tuner port ( 3.1.8 ) , or optical fibre port ( 3.1.25 ) with metallic shielding and/or metallic strain relief member(s) 5) 2nd edition (2005). This 2nd edition has been replaced in 2014 by a 3rd Edition IEC 61000-4-5:2014 , Electromagnetic compatibility (EMC) – Part 4-5: Testing and measurement techniques – Surge immunity test . 6) 3rd edition (2008).
This 3rd edition has been replaced in 2013 by a 4th Edition IEC 61000-4-6:2013 , Electromagnetic compatibility (EMC) – Part 4-6: Testing and measurement techniques – Immunity to conducted disturbances, induced by radio-frequency fields . 2