SC-B9580 User's Guide Problem Solver 101 Messages What to do The roll core is spinning. Check whether the media is loose. Printing can continue. Take-up reel stopped because the roll core was spinning. Reload media correctly on the take-up reel. The roll core is spinning. Remove the media from the media holder, and then reload the media. Media is not correctly attached to the media feeding unit or the auto take-up reel unit. Check the condition of the media and reattach it correctly if necessary. U “Loading Media” on page 38 U “Using the Auto Take-up Reel Unit” on page 40 The inside of the printer is hot. Lower room temperature.
Lower the temperature of the room until it is within the temperature range described in the "Specifications Table." U “Specifications Table” on page 126 The inside of the printer is hot, so it cannot be used. Turn printer off. Wait for printer to cool down, and then turn on the power. Turn off the printer's power, and lower the temperature of the room until it is within the temperature range described in the "Specifications Table." When the temperature of the room has fallen, turn on the printer's power. The same error will occur, even with the power on, if the temperature has not completely fallen. U “Specifications Table” on page 126 The media is low.
The remaining amount of loaded media is running low. Prepare new media. The media is not loaded correctly. Lower the media loading lever towards the rear, remove the media, and then reload the media. Media was not correctly loaded when it was loaded. Refer to the following, and load the media correctly. U “Loading Media” on page 38 There is a problem with the media or the print results; auto adjust cannot be done. Adjust manually. The scanning device may be malfunctioning. Contact Epson Support. Manual adjustment is possible. Pressing OK cancels the error. When doing Auto execution of Print Adjustments, execution is not possible for the following media, settings, and environment.
❏ Media with an uneven surface ❏ Media that bleeds-through easily ❏ The printer is used in a place that is exposed to direct sunlight or interference from other ambient light sources. In these cases, execute the manual menu. U “Optimizing Media Settings (Print Adjustments)” on page 47 If the printer is exposed to interference from ambient light sources, shade the printer from these sources and perform the function again; it may succeed. When the function has failed after shading the printer, execute the manual menu. If the above items do not apply, and the same error occurs again, contact your dealer or Epson Support.