Chapter 7: sDIO Module Panel-Mounting the sDIO Module To panel-mount the sDIO module, install one bracket on each side of the back of the unit, as shown in the following figure. Use the screws from the accessories kit. 186.5 14.0 Units are mm 10.0 18.0 27.6 273.9 2x 40356-00000 4x M3 x 6 mm 16.0 6.6 346.4 R 3.6 359.6 Figure 7-3. Panel-Mounting the sDIO Module Table-Mounting the sDIO Module To table-mount the sDIO module, install two brackets on each side near the bottom of the unit, as shown in the following figure. NOTE: These brackets must be ordered separately. They do not come with the sDIO module. SmartController EX User’s Guide, 11069-000 Rev. F Page 59 of 92