Chapter 4 Advanced Usage Functions Power ON notification • Disabled (initial setting) • Enabled Handshaking (Condition for BUSY) • Receive buffer full/Offline (initial setting) • Receive buffer full In either case above, the printer enters the BUSY state after power is turned on, and when a self-test is being run.
Data reception error • Prints “?” (initial setting) • Ignore Auto line feed • Always disabled (initial setting) • Always enabled Power saving function for USB • Disabled (initial setting) • Enabled The USB power-saving function is valid only when the USB interface communication condition is set to the vendor-defined class and the system configuration allows the USB driver to support the USB power-saving function. Roll paper end/near-end sensors • Enabled (Roll paper end sensor) (initial setting) • Disabled This printer is not equipped with the roll paper near-end sensor. Error signal output • Enabled (initial setting) • Disabled 81