JAC Owner's Manual (EN)

All information in this Owner's manual is current at the time of publication. However JAC reserves the right to make changes at any time so that our police of continual product improvement may be car 鄄 ried out. This manual applies to all current JAC models equipped with 4DA1series engine explanation of op 鄄 tion as well as standard equipment. As a result, you may find material in this manual that does not apply to your specific vehicle.

Стр. 1

Foreword Contents T hank you for choosing JAC. We are pleased to welcome you to the growing number of different Page Importance 1 Locations of chassis number and engine number 2 Location of the vehicle nameplate 2 Overload 3 Information about new vehicles 5 Vehicle operation and management 7 Maintenance 7 Cabin tilting mechanism 8 Cabin lockup 10 Controller and instrument 13 Cabin heater, defroster, air conditioning 35 CD and Radio 43 Before driving 51 Operation of controllers 52 Daily check list for drivers 60 people who drive JAC. The advanced engineering and high-quality construction of each JAC we build is something of which we are proud.

This Owner's Manual will introduce you the features and operation of your new vehicle. It is suggested that you read it carefully since the information it contains can contribute greatly to the satisfaction you receive from your new vehicle. The manufacturer also recommends that all service and maintenance on your vehicle be performed by an authorized JAC dealer. JAC dealers are prepared to provide high-quality service, maintenance and any other assistance may be required. ANHUI JIANGHUAI AUTOMOBILE CO., LTD. May. 2008

Стр. 2

Driving 71 Preparations before startup 72 Engine startup 73 Before vehicle running 74 Engine stopping 76 Parking 77 Attention poitns for driving 78 Economic driving 83 Vehicle management and maintenance in winter 86 Running on ice or snow 88 In emergence cases 90 Repair and maintenance 101 Schedule of regular maintenance 104 Guide to maintenance 108 Recommended brands of lubricats and diesels 139 Lubrication 140 List lubrication point 141 Guide to lubrication 142 Technical specification 149 Importance 1

Стр. 3

OWNER 爷 S MANUAL JAC High end Light Trucks The followings are very important for the correct management and economic use of JAC vehicles, and code is attached on the dashboard near the right column. they shall be read carefully before use and maintenance. Locations of chassis number and engine number Overload Please note down the chassis number and engine number, so as to give them to the specified JAC maintenance stations in case of repair and maintenance. Overloading will shorten vehicle's service life, but also bring about potential risk to safe driving. The loading mass must be limited to the specified range of the max.

total mass for vehicle, and the load distributions on the front and rear shafts shall not be more than the carrying capacity of the vehicle shafts. Please refer to the techni 鄄 Chassis number The chassis number, which is VIN code number, is stamped on the outer side cal specification sheet for the rated total mass value and shaft loading capacity. of the right longeron end of the frame. Engine number The engine cylinder head is affixed with the engine tag, on which it is marked with information about the engine, such as its model, serial number, nominal horse power, rated engine speed, ex-works date, etc.

Location of the vehicle nameplate The embossed number of VIN code for vehicle and Type II chassis is located on the outer side of the right longeron of the frame as well as, on the back side of the rear support of the rear leaf spring. Besides, an individual tablet of VIN 2 3

Стр. 4