EWI4000S-01-05 (EN)

SERVICE MANUAL PECIFICATION Type / Wind-instrument type controller with sound module Fingering / Saxophone fingering and EWI fingering Sensors / Note Keys: touch sensors Mouthpiece Breath: air pressure level sensor Lip: pressure level sensor
               Glide Plate: touch sensor Octave Shift Rollers:

touch sensors Program key / touch sensor Keys / "LEVEL key, FX key, SETUP key, TRANSPOSE key OCT key, HOLD key" Sensor Adjustment / "Breath Sense, Breath Adjustment, Bend Width, Bend Adjustment,""Glide Time, Glide Adjustment, Vibrato Adjustment" Terminals / LINE OUT x 1 (1/4 inch Phone Jack) "Headphones OUT x 1 (Dual Mono, Stereo Mini Jack,)" (The recommended minimum headphone impedance is 32 ohoms) "MIDI IN x 1, MIDI OUT x 1 (5-pin DIN)" DC IN x 1 (for optional AC adaptor MP-9II) Other / Removal Cable Clutch Power requirement / AA (ALKALINE or Rechargeable) battery x 4 ( Approx.

8 hours continuous use by batteries except using Headphones)or 9VDC/200mA AC-adaptor MP-9II (Optional) Dimensions / 670.5mm(L) x 61mm(W) x 69mm(D) Weight / 874g (not included Batteries) Accessories / "Operator's Manual, Neck strap, AA battery x 4, Cleaning Cloth, Mouthpiece Cover" MODEL: EWI4000S

Стр. 1

DISASSEMBLY PROCEDURES 1.DISASSEMBLE THE COVER MOUTH PIECE . (A) REMOVE 1 PC SCREW FROM THE COVER MOUTH PIECE . (Fig1) 1. DISASSEMBLE THE PANEL BOTTOM . (A)REMOVE 1 PC SCREW AND WASHER SCREW FROM THE COVER BATTERY . (B) (C) (D) REMOVE 2 PCS SCREWS FROM THE PANEL BOTTOM . (E)REMOVE 11 PCS SCREWS FROM THE PANEL BOTTOM . (Fig.2)

Стр. 2

3.DISASSEMBLE THE GND PCB ASS’Y . (A) REMOVE 2 PCS SCREWS FROM THE PANEL BOTTOM . (B) REMOVE 2 PCS SCREWS AND 2 PCS WASHERS FROM THE GND PCB ASS’Y . (Fig.3) 2. DISASSEMBLE THE PANEL MAIN EWI4000S . (A) REMOVE 2 PCS SCREWS FROM THE PANEL MAIN EWI4000S . (B) REMOVE 4 PCS SCREWS FROM THE BATTERY PCB ASS’Y . (C) REMOVE 1 PC WASHER AND 1 PC NUT FROM PANEL MAIN EWI4000S . (D) REMOVE 4 PCS SCREWS FROM THE PANEL MAIN EWI4000S . (E) SEPARATE PANEL MAIN EWI4000S AND TOP PANEL . (Fig.4)

Стр. 3

5.DISASSEMBLE ROLLER PCB ASS’Y AND SEGMENT PCB ASS’Y AND MIDI PCB ASS’Y . (A) REMOVE THE ROLLER PCB ASS’Y FROM MAIN PCB-A ASS’Y . (B) REMOVE 2 PCS SCREWS FROM PANEL TOP . (C) REMOVE THE CABLE FROM MIDI PCB ASS’Y . (D) REMOVE 2 PCS SCREWS FROM PANEL TOP . (Fig.5) 6.DISASSEMBLE MAIN PCB-A ASS’Y AND SIDE PCB ASS’Y . (A) REMOVE 2 PCS SCREWS AND 2 PCS WASHERS FROM PANEL TOP . (B) REMOVE THE CABLE FROM THE MAIN PCB –A ASS’Y . (Fig.6)

Стр. 4