Руководство по эксплуатации EV зарядного устройства PulseQ AC Mini (EN)

CONTENTS Section 1 - Precautions ............................................................... 4 Section 2 - Standards Compliance ............................................................... 8 Section 3 - What's in the Box ............................................................... 11 Section 4 - Product Overview ............................................................... 12 Section 5 - Installation ............................................................... 20 Section 6 - How to Charge an EV ............................................................... 36 Section 7 - Fault Handling ...............................................................

40 Section 8 - Warranty ............................................................... 42

Стр. 3

Section 1 - Precautions 1.1 IMPORTANT SAFETY PRECAUTIONS WARNING - When using electric products, the tool's safety precautions should always be followed. Follow the instructions below closely. 1. Read all the instructions before using this product. This manual contains important instructions for the PulseQ AC Mini charger which shall be followed during the installation, operation, and maintenance of the charger. 2. Children should be supervised if they are in the vicinity of the PulseQ AC Mini while the product is in use. Children should not use this device. 3. Do not put any of your or another person's body, clothing, or accessories into the tool's Electric Vehicle (EV) connector. 4.

Do not use this product if the charging cable is frayed, has broken insulation, or has any other signs of damage (applicable to models that come with a charging cable). 5. Do not use this product if the enclosure or the charging plug / socket is broken, cracked, open, or shows any other indication of damage. 6. Note the operating temperature rating (-30°C to +50°C). 4

Стр. 4

WARNING A certified AC Surge Protection Device (SPD) is suggested to be installed upstream close to the charging station. SPDs shall comply with standard IEC / EN 61643-11, and the rated voltage against lightning overvoltage shall be up to 2.5kV. A certified Type A or Type B Residual Current Device (RCD) must be installed upstream, close to the EV charger. The RCD shall have a 1-phase 40A rated current and comply with one of the following standards: IEC 61008-1, IEC 61009-1, IEC 60947-2 or IEC 62423.

All these protection devices shall be chosen based on the appropriate technical specifications, i.e., working voltage ≥ charging station working voltage, working current ≥ charging station working current, Ingress Protection (IP) ≥ IP54 or installed inside IP54 protection box for outdoor use. 5

Стр. 5

1.2 SAFETY NOTES 1.2.1 Safety Signs Used The following types of signs are used in this manual and on the charger. They must be adhered to. CAUTION: Electrical hazard. This indicates severe personal injury or substantial property damage can result if the device is not operated as instructed. ATTENTION: This indicates minor personal injury or material damage can result if the device is not operated as instructed. CAUTION: Do not touch in case of Electrostatic Discharge (ESD). Indicates possible consequences of touching electrostatically sensitive components. No access for unauthorized persons. The user must wear safety gloves. The user must wear protective footwear.

The user must wear a safety helmet. Indicates important texts, notes, or tips. 6

Стр. 6