AH Motion Controller – Operation Manual _9 9-58 Error Code Description Corrective action 16#740D The slot number in a communication command is incorrect. Please check the PLC firmware and the software version and contact the supplier. 16#740E Error occurs when clearing the memory Please try again. If the error occurs again, contact the supplier. 16#740F Communication timeout Check if the device to be connected is in normal operation. 16#7410 The received Function Code doesn’t match the current Function Code. Check the packet content sent by the remote device. 16#7412 Data cannot be downloaded to CPU because SW1 is ON. Confirm that SW1 is OFF.
16#757D The number of times users can enter the PLC password is 0. The password retry limit is reached. Please power on the PLC again. 16#757E Incorrect PLC password Check if the password is correct. 16#8105 The contents of the program downloaded are incorrect. The program syntax is incorrect. Download the program again. 16#8106 The contents of the program downloaded are incorrect. The length of the execution code exceeds the limit. Download the program again. 16#8107 The contents of the program downloaded are incorrect. The length of the source code exceeds the limit. Download the program again. 16#8230 The CPU parameter downloaded is incorrect. The IP address is illegal.
Check the network related parameter which is downloaded to the CPU. 16#8231 The CPU parameter downloaded is incorrect. The netmask address is illegal. Check the network related parameter which is downloaded to the CPU. 16#8232 The CPU parameter downloaded is incorrect. The gateway address is illegal. Check the network related parameter which is downloaded to the CPU.