MAINTENANCE SECTION 2 Page 42 REPLACING INNER ELEMENT 1 First remove the cover and the outer element, and then remove the inner element. 2. Place the cover over the air intake part to prevent dust entering Clean the air cleaner body interior, then remove the cover from the air intake port. 3. Fit a new inner element and tighten it with nuts. 4. Install the outer element and the cover. Push the dust indicator reset button. Note: Do not attempt to reinstall a cleaned inner element. A WARNING! Do not clean or replace the air cleaner element with the engine running.
CLEANING OUTER ELEMENT With compressed air Direct dry compressed air (less than 7 kg/cm’) to element from inside along its folds, then direct it from outside along its folds and again from inside, and check element. A WARNINGI When using compressed air, wear safety glasses and other things required to maintain safety. The following methods require spare pans. With water Dash city water (less than 3 kg/cm2) on element from inside along folds, then from outside and again from inside. Dry and check it. With cleaning agent For removing oils and fats as well as carbon etc.
attached on the element, the element may be cleaned in lukewarm solution of mild detergent, then rinsed in clean water and left to drip dry. * Drying can be speeded up by blowing dried compressed air (less than 7 kg/cm’) from the inside to the outside of the element. Never attempt to heat the element * Using warm water (about 40°C) instead of soapy water may also be effective. * If small holes or thinner pans are found on [ element when it is checked with an electric bulb after cleaning and drying, replace the element. * If element is usable, wrap it and store it in dry place. I Do not use element whose folds or gasket or seal are damaged.
* When cleaning element, do not hit it or beat it against something.