Cummins — CLEAN RADIATOR FINS

MAINTENANCE SECTION 2 Page 43 CHECK AND REFILL TRANSMISSION OIL Carry out this procedure if there is any sign of oil on the transmission case, or if there is oil mixed with the cooling water. Stop the engine and remove the cap of oil filler (F). Use dipstick (G) to check the oil level. The oil level should be between mark L and l-i, if necessary, add oil at the oil filler (F). The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS”. There are two sets of level marks on the same side of the dipstick:

one is for measuring when the engine is stopped (ENGINE STOP), and the other is for measuring when the engine is idling (ENGINE IDLE). When measuring the oil level, wait for at least 60 minutes after stopping the engine, and measure with the ENGINE STOP marks. It is possible lo measure when the engine is at low idling, but in such cases, do as follows. Start the engine and run it until the oil level is stable, then wait for 5 minutes and measure with the ENGINE IDLE marks. WARNING! When checking the oil level, apply the parking brake, and lock the front and rear frames with the safety bar and pin.

CLEAN RADIATOR FINS Carry out this procedure if there is any mud or dirt seen stuck to the radiator. 2. Clean the radiator fins and oil cooler fins clogged with mud, dust and leaves with compressed air. Steam or water may be used instead of com- pressed air. 1. Loosen bolt (1) and remove radiator grille (2). * The rubber hose should be checked at the same time. If the hose is found to have cracks or to be hardened by aging, such hose should be replaced by new one, Further, loosened hose clamp should also be checked.