8.1 TUBE AND SHELL BOLTED FLANGE EGR COOLER 1. Install the EGR water outlet hose and clamps onto the oil cooler inlet. See Figure 8-10. 1. Bolt 3. Clamp 2. EGR Water Inlet Hose 4. TSBF EGR Cooler Figure 8-10 EGR Cooler and Related Parts 2. Insert the oil cooler inlet hose over the cooler water outlet. Secure the hose with clamps. PERSONAL INJURY To avoid injury when removing or installing a heavy engine component, ensure the component is properly supported and securely attached to an adequate lifting device to prevent the component from falling. 3. Align the cooler back plate holes with the four bosses on the cylinder block. 4.
Thread four M10 bolts through the back plate and into the cylinder block. Torque bolts to 46-52 N·m (34-38 lb·ft). 5. Install the hose and clamps onto the cooler water inlet. See Figure 8-10. 6. Insert the water pump outlet elbow into the EGR cooler water inlet hose. Secure the hose with clamps. 7. Install a new seal ring on the water pump elbow and secure the elbow with two M10 bolts. Torque bolts to 58-73 N·m (43-54 lb·ft). (Rev. 2005) All information subject to change without notice. 8-12 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION