SERIES 60 SERVICE MANUAL 3. Unplug the sensor harness (2) from the VPOD assembly (4). See Figure 8-39. 1. Bolt 3. Stud 2. Sensor Harness 4. VPOD Assembly Figure 8-39 VPOD and Related Parts 4. Remove the bolts (1) and stud (3) securing the VPOD assembly (4) with bracket to the engine block. See Figure 8-39. Remove the VPOD assembly. 8.5.1.1 Inspection and Testing of VPOD Inspection steps are as follows: 1. To test the VPOD, refer to the Exhaust Gas Recirculation System Basic Checks Section found in the DDEC V Single ECU Troubleshooting Guide , 6SE565. [a] If the VPOD is defective, replace the component. [b] If the VPOD is not defective, reuse the component for installation. 2.
Visually check the sensor harness for damage. [a] If the harness is damaged, repair as necessary and refer to the Wiring and Wires and Conduit and Loom sections found in the DDEC V Single ECU Troubleshooting Guide , 6SE565. [b] If the harness is not damaged, reuse the harness for installation. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 8-45