SERIES 60 SERVICE MANUAL 1.10.2.1 Inspection of Gear Case Cover Inspect the gear case cover as follows: 1. Clean all of the old gasket sealer from the mating surfaces of the gear case and gear case cover. Refer to General Information, "Cleaning". 2. Clean the gasket material from the mating surfaces of any components or access covers that were removed from the gear case cover, and the gear case cover itself. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 3.
Clean all of the removed parts except the electrical components with clean fuel oil and dry with compressed air. NOTE: Any time the gear case cover is removed, the crankcase oil seal must be replaced. Install the new front oil seal after the gear case cover has been installed to the engine. 4. If necessary, remove the crankshaft front oil seal at this time. Refer to section 1.8.2. Inspect the gear case cover for stress cracks or breaks in the casting. Refer to section 1.10.2.1. Repair or replace as necessary. Refer to section 1.12.3. 5. Inspect all O-rings for signs of dryness or splitting. Replace as necessary.
1.10.3 Installation of Gear Case Cover Perform the following steps for gear case installation: 1. Apply a continuous 1/16 in. bead of Gasket Eliminator PT-7276 (Loctite® 518) or equivalent to the mating surface of the gear case. NOTE: Gasket eliminator cures with the absence of air. The length of time between gear case cover installation and torquing the bolts that secure the gear case cover to the gear case should be kept to a minimum. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-185