Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL NOTICE: With gasketless parts such as the gear case cover; the torque values and tightening sequences are critical to prevent parts warpage. [a] Install the shorter bolts, No. 1 through 16, 21, 22 (see note), in various locations at the front of the gear case cover. Finger-tighten them. Remove the guide studs when installing bolts 7 and 14. See Figure 1-166. NOTE: Bolts 21 and 22 are rear bolts on pre-1991 engines. Figure 1-166 Gear Case Cover Bolt Torque Sequence (Front) [b] Torque bolts 1 through 16, 21, 22 (see note), to 58-73 N·m (43-54 lb·ft). [c] Install the front engine mount to the gear case cover.

Install the four, longer, front engine mount-to-gear case cover bolts, finger-tight. [d] Torque bolts 17, 18, 19 and 20 to 160-200 N·m (118-148 lb·ft). See Figure 1-166. [e] Bolts F1 through F5 are fan support bracket bolts. Install the fan support bracket and torque bolts F1, F2 and F3 to 58-73 N·m (43-54 lb·ft). Torque bolts F4 and F5 to 160-200 N·m (118-148 lb·ft). All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-187