Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.11 GEAR CASE COVER EXHAUST GAS RECIRCULATION (EGR) MODEL To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. EYE INJURY 3. Clean all of the removed parts, except the electrical components, with clean fuel oil and dry with compressed air. NOTE: Any time the gear case cover is removed, the crankcase oil seal must be replaced. Install the new front oil seal after the gear case cover has been installed to the engine. 4. If necessary, remove the crankshaft front oil seal at this time. Refer to section 1.8.2.

Inspect the gear case cover for stress cracks or breaks in the casting. Repair or replace as necessary. 5. Inspect all O-rings for signs of dryness or splitting. Replace as necessary. 1.11.3 Installation of Gear Case Cover EGR Model Perform the following steps for gear case cover installation: 1. Apply a continuous bead of Loctite® 518 (gasket eliminator) or equivalent to the mating surface of the gear case. NOTE: Gasket eliminator cures with the absence of air. The length of time between gear case cover installation and torquing the bolts that secure the gear case cover to the gear case should be kept to a minimum. NOTE: Ensure seal is installed in the rear of thr gear case cover (Rev.

2005) All information subject to change without notice. 1-202 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION