Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL NOTICE: Inspect the piston ring compressor for nicks or burrs, especially at the non-tapered inside diameter end. Nicks or burrs on the inside diameter of the ring compressor may result in damage to the piston rings. 8. Install the tapered end of the piston ring compression tool over the end of the connecting rod, and down onto the piston. As the compression tool slides down the piston to the piston ring area, apply slow, even pressure on both sides of the compression tool to compress the rings. See Figure 1-305. Figure 1-305 Installing Piston and Connecting Rod Assembly into Ring Compressor 9.

Slide the compression tool down until it contacts the bottom of the drain pan. 10. Position the crankshaft so that the connecting rod journal for the cylinder being worked on is at bottom-dead-center. 11. Remove the cap from the connecting rod. NOTICE: Do not allow the connecting rod to contact the cylinder liner on installation, or damage to the liner may occur. The numbers on the side of the connecting rod and cap identify the rod with the cap and indicate the particular cylinder in which they are used.

If a new service connecting rod is to be installed, the same identification numbers must be stamped in the same location (on the tang side of the rod and cap) as on the connecting rod that was replaced. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-331