1.24 GEAR TRAIN AND ENGINE TIMING 12. Check the bull gear-to-water pump drive gear lash measurement for 1991 and later engines with water pump gear lash tool (J–38977–A) as follows: [a] Remove the pipe plug in the gear case cover. [b] Install the water pump gear lash tool (J–38977–A) through the hole in the gear case and thread it into the special water pump drive gear retaining bolt. See Figure 1-356. Figure 1-356 Water Pump Gear Lash Tool Method [c] The arm of this tool has an inscribed line. Measuring with a dial indicator at this line of the tool, the gear lash measurement will be an exact 1:1 reading. Gear lash specifications are 0.051-0.229 mm (0.002 -0.009 in.).
[d] If proper lash cannot be obtained, replace the gear with a new part. Refer to section 1.33.2. [e] Remove the dial indicator and the gear lash tool. [f] Install the pipe plug in the gear case cover. Torque to 24-31 N·m (18-23 lb·ft). 13. Check the bull gear-to-water pump drive gear lash measurement of pre-1991 engines (with the water pump impeller slip tester method) as follows. NOTE: Skip step 13 and the following step 14, if the engine was built after 1990. NOTE: The bull gear-to-water pump drive gear lash can be measured using the water pump impeller slip tester (J–35687), or by inserting a bolt into one of the tapped holes in the water pump impeller.
The lash can then be measured using a dial indicator. (Rev. 2005) All information subject to change without notice. 1-394 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION