Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL [a] Install the water pump impeller slip tester (J–35687), to the water pump impeller with two 5/16-18 bolts, using the instructions supplied with the tool. See Figure 1-357. Figure 1-357 Water Pump Drive Gear Lash Measurement [b] One leg (the long one) of the tool has an inscribed line. Measuring with a dial indicator at this line of the tool, the gear lash measurement will be an exact 1:1 reading. Gear lash specifications are 0.051-0.229 mm (0.002 -0.009 in.). [c] If proper lash measurement cannot be obtained, replace the gear with a new part. Refer to section 1.33.2. All information subject to change without notice. (Rev.

2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-395