Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.24 GEAR TRAIN AND ENGINE TIMING 14. Check the bull gear-to-water pump drive gear lash measurement for pre-1991 engines (with the bolt method) as follows: [a] Install a 5/16-18 bolt and nut into one of the tapped holes in the water pump impeller. See Figure 1-358. Figure 1-358 Water Pump Drive Gear-to-Bull Gear Lash Measurement [b] Install a magnetic dial indicator base and dial indicator. See Figure 1-358. [c] Position the stem of the dial indicator on a flat of the bolt. [d] Preload the water pump impeller. [e] Zero the dial indicator. [f] Rotate the water pump impeller, read and record the total gear lash. Multiply this reading by 2.45 to obtain actual lash.

Gear lash measurements are 0.051 to 0.229 mm (0.002 -0.009 in.). [g] If proper lash cannot be obtained, replace the gear with a new part. Refer to section 1.33.2. [h] Remove the dial indicator base and dial indicator. [i] Remove the bolt and nut from the water pump impeller (if used). [j] Inspect the rubber seal ring on the water pump cover for splitting or cracks. Install a new seal, if necessary, between the water pump cover and the water pump housing. Refer to step 11, and perform step 11[g]. [k] Install the two bolts that secure the water pump cover to the water pump housing. Torque the bolts to 30-38 N·m (22-28 lb·ft). (Rev. 2005) All information subject to change without notice.

1-396 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION