Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 15. Check the bull gear-to-air compressor drive gear lash measurement as follows: [a] Mount a magnetic dial indicator base and dial indicator to the gear case cover so that the stem of the dial indicator may be positioned on a tooth of the air compressor drive gear. [b] Preload the drive gear in one direction. [c] Zero the dial indicator. [d] Rotate the air compressor drive gear, read and record the total gear lash. Gear lash measurements are 0.051-0.229 mm (0.002 -0.009 in.) for new parts, with a maximum of 0.305 mm (0.012 in.) for used gears. [e] If proper lash cannot be obtained, replace the gear with a new part. Refer to section 1.33.2.

[f] Remove the dial indicator and magnetic base. [g] Install the power steering drive coupling to the air compressor drive gear (if equipped with power steering) and insert a new O-ring on the power steering pump (if so equipped). [h] Install the power steering pump to the gear case cover, meshing the drive coupling properly. [i] Install and torque the power steering pump mounting bolts to 30-38 N·m (22-28 lb·ft). Tighten the five bolts alternately and evenly, in a star-shaped pattern, to progressively draw the power steering pump into the gear case cover. NOTE: Do not force the bolts. If resistance is encountered, remove the power steering pump and re-engage the drive hub with the coupling.

[j] If the engine is not equipped with power steering, install the air compressor drive gear access cover using a new gasket. [k] Install and torque the retaining bolts to 30-38 N·m (22-28 lb·ft), using a star-shaped pattern. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-397