Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.36 JAKE BRAKE 3. Slowly remove cover until spring pressure ceases, then remove the two control valve springs and collar. See Figure 1-533. 1. Jake Brake Assembly 5. Washer 2. Control Valve 6. Collar Spring 3. Collar 7. Control Valve Spring 4. Snap Ring Retainer Figure 1-533 Removing Control Valve Springs and Collar 4. Using needle-nose pliers, reach into the bore and grasp the stem of the control valve. Remove control valve. Remove the slave piston adjusting screw as follows: 1. Loosen slave piston adjusting screw locknut. (Rev. 2005) All information subject to change without notice. 1-596 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION