Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 1.36.3.1 Cleaning of Model 760, 765, or 770 Jake Brake Clean the Jake Brake as follows: NOTE: Use an OSHA-approved cleaning solvent when washing parts. Be sure to coat parts with clean engine oil when reinstalling them. 1. Wash the control valves with approved cleaning solvent. 2. Push a wire through the hole in the base of the valve to the distance required to ensure that the ball check is free. NOTE: The ball should lift with light pressure on the wire. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 3.

Dry the valve with compressed air, and wipe clean with a paper towel. 4. Thoroughly clean the control valve bore in the housing using clean paper towels. 5. Clean slave piston adjusting screw in an approved cleaning solvent. 6. Clean out the solenoid valve bore in the housing. NOTICE: Use clean paper towels to clean the solenoid valve bore. Never use rags, as they may leave lint and residue which can plug the oil passageways, causing Jake Brake malfunction. 7. Clean the master piston in approved cleaning solvent. 1.36.3.2 Inspection of Model 760, 765, or 770 Jake Brake The Jacobs engine brake is typically a trouble-free device.

However, inspections are necessary and some maintenance is required. Use the following procedures to keep the engine brake in top condition. Inspect the Jake Brake as follows: All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-603