1.36 JAKE BRAKE 1. Inspect slave piston adjusting screw for protrusion, spring pressure and freedom of movement. NOTE: The plunger should protrude from the bottom of the screw, have light spring pressure apparent when depressed, and move freely. Be sure the retaining ring is fully engaged in its groove (groove is located on the bottom of the reset screw and top of the POWER-LASH assembly). [a] If the plunger does not protrude, the spring does not have light pressure or does not move freely, replace the entire screw assembly. Refer to section 1.36.4 [b] If the slave piston adjusting screw meets specifications, continue with inspection. 2. Inspect the accumulator for wear or damage.
[a] If worn or damaged, replace the accumulator. Refer to section 1.36.4. [b] If accumulator is not worn or damaged, continue with inspection. 3. Inspect the master piston bore for wear or damage. NOTE: Some wear marks are permissible. [a] If worn or damaged, replace the master piston. Refer to section 1.36.4. [b] If not worn or damaged, continue with inspection. 4. Apply clean lube oil to the piston, and insert into bore. NOTE: Master piston should move in and out freely with no binding. [a] If binding occurs, replace master piston and/or housing. Refer to section 1.36.4. [b] If no binding occurs, continue with inspection. 5. Inspect master piston spring for relaxation. NOTE:
The spring should hold the master piston completely in the housing. [a] If relaxed, replace the spring. Refer to section 1.36.4. [b] If spring holds tightly, continue with inspection. 6. Inspect the ball check valve (Model 760 only) for wear or damage. [a] If worn or damaged, replace ball check valve. Refer to section 1.36.4. [b] If not worn or damaged, proceed with inspection. 7. Inspect slave piston components for excessive wear or damage. [a] If worn or damaged, replace slave piston component. (Rev. 2005) All information subject to change without notice. 1-604 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION