SERIES 60 SERVICE MANUAL [b] If not worn or damaged, proceed with inspection. 1.36.3.3 Inspection of Control Valve Inspect the control valve as follows: 1. Dip the control valves in clean lube oil. 2. Holding the control valve by the stem, let it drop into the bore. [a] If binding occurs or if the ball sticks in the valve, replace the control valve. Refer to section 1.36.4. [b] If no binding occurs and the ball does not stick in the control valve, assemble the Jake Brake. Refer to section 1.36.4. 1.36.4 Assembly of Model 760, 765, or 770 Jake Brake Install the control valve as follows: 1. Slip the control valve into the bore. See Figure 1-541. NOTE:
Make sure the control valve collar is installed with the longer sleeve area facing up. If the collar is installed upside down, the engine brake cylinder will not operate. 1. Jake Brake Assembly 5. Washer 2. Control Valve 6. Collar Spring 3. Collar 7. Control Valve Spring 4. Snap Ring Retainer Figure 1-541 Installing the Control Valve All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-605