Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.36 JAKE BRAKE 2. Install the control valve collar and two springs. NOTE: Ensure the collar is installed with the longer sleeve area facing up. If the collar is installed upside down, the engine brake cylinder will not operate. 3. Press the cover (washer) into place. 4. While holding the cover tightly in place, install the retaining ring. 5. Rotate retaining ring ears 90 degrees to assure ring is seated in groove. Install the slave piston adjusting screw as follows: 1. Place the screw in the housing. See Figure 1-542. 1. Jake Brake Assembly 2. Slave Piston Adjusting Screw Figure 1-542 Installing the Slave Piston Adjusting Screw 2.

Torque the slave piston adjusting screw locknut to 35 N·m (25 lb·ft). Install the solenoid valve as follows: NOTE: As of October 19, 1997, former solenoids have been replaced with the current improved solenoids. The current solenoids have an increased installation torque and improved durability. The current solenoid is interchangeable with the former. 1. Coat new solenoid valve seal rings with clean lube oil. NOTE: Use current upper seals when installing current solenoids. New seals are identified with yellow stripes. (Rev. 2005) All information subject to change without notice. 1-606 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION