Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 2. Install the upper and center seal rings on the solenoid valve body and the lower seal ring into the bottom of the bore in the housing. See Figure 1-543. 1. Seal Rings (3) 2. Solenoid Figure 1-543 Installation of Solenoid Valve Seal Rings 3. Make sure the seals are seated properly. 4. Using a 7/8 in. socket and extension for former solenoids or a 3/4 in., 6 point socket and extension for current solenoids, carefully screw the solenoid valve into the housing without unseating the seals. 5. Torque the former solenoid to 12.4 N·m (9 lb·ft). Torque the current solenoid to 20 N·m (15 lb·ft.) NOTE: Be careful not to twist the seals while installing.

Install the accumulator as follows: 1. Place the piston into the accumulator bore. 2. Insert the spring, and install the cover. 3. Push down the accumulator cover, and insert retaining ring. Install the master piston as follows: 1. Apply clean lube oil to the piston. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-607