1.36 JAKE BRAKE 1. Insert slave piston into bore. See Figure 1-563. 1. Solenoid Valve 9. Master Piston Retaining Ring 17. Slave Piston 2. Solenoid Upper Seal Ring 10. Control Valve 18. Slave Piston Bridge 3. Solenoid Center Seal Ring 11. Outer Control Valve Spring 19. Outer Slave Piston Spring 4. Solenoid Lower Seal Ring 12. Inner Control Valve Spring 20. Inner Slave Piston Spring 5. Master Piston 13. Control Valve Cover 21. Spacer Tube 6. Master Piston Pushrod 14. Retaining Ring 22. Shoulder Bolt 7. Master Piston Spring 15. Adjusting Screw* 23. Drive Screw 8. Master Piston Retainer 16. Locknut 24. Wire Harness Clip *Note that Model 790 Jake Brake uses a J-Lash assembly.
Model 795 Jake Brake uses a solid screw. Figure 1-563 Typical Model 790/795 Jake Brake Assembly 2. Install slave piston bridge. See Figure 1-563. EYE INJURY To avoid injury from flying parts when working with components under spring tension, wear adequate eye protection (face shield or safety goggles). 3. Install new springs and shoulder bolt. Torque bolts to 23 N·m (17 lb·ft). See Figure 1-563. 4. Repeat step1 through step 3 for installing the remaining slave pistons. (Rev. 2005) All information subject to change without notice. 1-630 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION