SERIES 60 SERVICE MANUAL 5. To ensure proper installation of the slave piston, use the following procedure as a check. [a] Loosen the adjusting screws nuts and back off the adjusting screws sufficiently to allow the slave pistons to retract fully into the bores. [b] Verify that all slave pistons have fully retracted to where the slave piston bridge, meets the housing. If any remain in the initially set position, identify the slave piston or pistons affected. [c] Disassemble the shoulder bolt, bridge, and springs; remove the affected slave piston or pistons, and clean the slave piston bore of any remaining oil. [d] Replace the pistons with the new slave piston replacement group.
If only one piston of the same cylinder is affected, replace both pistons within that cylinder. [e] After coating the new slave pistons with clean engine oil, inspect and verify that the new slave pistons drops to the bottom of the bore under its own weight or light pressure. In most cases, simply installing the new pistons will allow this to happen. If it does, proceed to step6. If it does not, proceed to step5[f]. [f] Remove the piston and look for a burr on the slave piston bore at the depth where the slave piston contacts the adjusting screw. [g] Use a triangle-shaped machinist's scraper, coating the tool with a generous amount of grease. See Figure 1-564.
Gently remove the raised burr until the surface is flush with the remainder of the bore. Figure 1-564 Removal of Slave Piston Bore Burr [h] Remove any remaining grease and debris using a soft cloth or paper towel. Most of the debris will be picked up by the grease. [i] Verify that slave piston now drops to the bottom of the bore under its own weight or light pressure. If not, repeat step5[a] through step 5[h]. [j] Reassemble the slave piston of the brake with step1 through step 3. [k] Adjust slave piston lash, refer to section 1.36.8.1. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-631