Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.36 JAKE BRAKE 6. Install the master piston and pushrod into the bore. See Figure 1-563. 7. Install new spring. See Figure 1-563. 8. Install new master piston retainer over spring. See Figure 1-563. 9. While depressing master piston retainer, insert the new master piston retaining ring with snap ring pliers. See Figure 1-563. NOTE: Rotate the retaining rings 90 degrees to ensure that the ring is seated in the groove. 10. Repeat step6 through step 9 for installing the remaining master pistons. 11. Flip housing over. 12. Install the adjusting screw and locknut. See Figure 1-563. NOTE: For Model 790 Jake Brakes install the J-Lash assembly screw.

For Model 795 Jake Brakes install the solid screw. NOTE: Do not tighten the locknut at this time. 13. Repeat step12 for installing the remaining adjusting screws and locknuts. 14. Slip the new control valve into the bore. See Figure 1-563. 15. Install new control valve springs. See Figure 1-563. 16. Place new control valve cover over springs followed by the retaining ring. See Figure 1-563. 17. Press down on the valve control cover with an appropriate diameter rod and set the retaining ring into the groove with snap ring pliers. See Figure 1-563. NOTE: Rotate the retaining ring 90 degrees to ensure that the retaining ring is seated in the groove. 18.

Repeat step14 through step 17 for installing the remaining control valves. (Rev. 2005) All information subject to change without notice. 1-632 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION