SERIES 60 SERVICE MANUAL 19. Install the lower (smallest) solenoid seal ring into the bottom of the solenoid valve bore. See Figure 1-563 and see Figure 1-565. NOTE: Coat the seals with clean engine oil prior to assembly. NOTE: New upper seal rings can be identified by a yellow stripe. 1. Seal Rings (3) 2. Solenoid Valve Figure 1-565 Installation of Solenoid Valve Seal Rings 20. Install the upper and center seal rings on the solenoid valve. See Figure 1-563 and see Figure 1-565. NOTE: Coat the seals with clean engine oil prior to assembly. NOTICE: Avoid cutting or twisting the seal rings while installing solenoid. Improper installation could result in poor engine brake performance. 21.
Ensure the solenoid seal rings are seated properly. 22. Using a 3/4 in.-6 point socket and extension; carefully screw in the solenoid valve into the housing without unseating the solenoid seal rings. Torque to 20 N·m (15 lb·ft). See Figure 1-563. 23. Repeat step19 through step 22 for installing the remaining solenoid valves. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-633