Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.36 JAKE BRAKE 1.36.8 Installation of Model 790/795 Jake Brake Assembly The installation procedures for the model 790/795 Jake Brake assemblies differ slightly from the former engine brakes. Two brake housings are used, instead of three, and spacer bars are not required. Install the model 790/795 Jake Brake assemblies as follows: NOTICE: To prevent cylinder head from cracking when bolts are torqued, remove the oil from the bolt holes. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 1.

Attach a length of tubing to an air gun nozzle and blow out the oil from the housing-hold down bolt holes. NOTE: Cover the holes with hand towels to minimize oil spray. 2. Place the engine brake housings on the rocker shafts and spacer tubes with the solenoids on the camshaft side of the engine and the slave pistons over the exhaust valves. 3. Lubricate each hold-down capscrew with clean engine oil. (Rev. 2005) All information subject to change without notice. 1-634 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION