Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 4. Install three 170 mm (6.693 in.) long capscrews on the solenoid side of the brake. See Figure 1-566. Figure 1-566 Housing Hold-Down Bolt Locations NOTICE: Installing 170 mm capscrews on the exhaust side of the engine can result in serious engine damage. 5. Install three 140 mm (5.152 in.) long capscrews and spacers on the exhaust side of the engine. See Figure 1-566. 6. Before tightening the capscrews, move the housing from side to side. Position housing in the center of the range of motion. 7. Tighten the capscrews or nuts in the following sequence for one engine brake assembly:

(See Figure 1-566.) [a] Starting with the middle capscrew, on the camshaft side and following the sequence shown, torque to 55 N·m (41 lb·ft). [b] Repeat the tightening sequence, final torque all to 108 N·m (80 lb·ft). 8. Connect the lead wires to the solenoid valves passing the wires through the wire clips. 9. Torque solenoid screw to 1 N·m (9 lb·in.). NOTE: Pull the lead wires away from the housing. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-635