Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.36 JAKE BRAKE 1.36.8.1 Set Slave Piston Lash The slave piston lash must be set after Jake Brake housings are installed. Adjustments must be made with the engine stopped and cold with the oil temperature at 60°C (140°F) or below. Exhaust valves on the cylinder must be in the closed position (rocker arm roller should be on the base circle of the camshaft). NOTICE: The slave piston adjustment procedure must be followed exactly. Failure to properly adjust Jake Brakes will result in inefficient engine brake performance and may lead to severe engine or Jake Brake damage. Adjust Model 790/795 Jake Brake slave piston lash as follows: 1.

Turn in the adjusting screw until the solid side of the slave piston bridge assembly, contacts the exhaust valve and the valve springs begin to compress, then turn in one additional turn. NOTE: Wait at least 30 seconds for oil to be purged from the J-Lash adjusting screw. If oil is below room temperature (below 16 °C [61°F]), wait at least two minutes for oil to be purged from the J-Lash adjusting screw. (Rev. 2005) All information subject to change without notice. 1-636 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION