Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL NOTICE: Serious engine damage may occur from improper lash setting. 2. Using a 3/16 in. hex wrench, back out the adjusting screw ONLY until the correct size feeler gage (listed in Table 1-9) can be inserted between the solid side of the slave piston bridge assembly and the exhaust valve. See Figure see Figure 1-567. 1. J-Lash Adjusting Screw 3. Exhaust Valve Spring 2. Slave Piston Figure 1-567 Setting Slave Piston Lash 3. Adjust the adjusting screw so that a light drag is felt on the feeler gage. Do not back out the adjusting screw more than required to obtain a light drag on the feeler gage.

Use a screwdriver to hold the adjusting screw in place and torque the lock nut to 38 N·m (336 lb·in.). See Figure 1-567. NOTE: If the J-Lash adjusting screw is backed out until it no longer compresses the slave piston spring, oil will enter the screw and the adjustment will be incorrect. If this occurs, repeat step2and step 3. NOTE: For Model 795 applications, skip to step 4. 4. Hold the solid adjusting screw in place and torque the locknut to 38 N·m (28 lb·ft). 5. Recheck lash settings. If lash setting is incorrect, repeat step 1 through step 3. NOTE: Once the engine brake has been run, you will not be able to check the engine brake adjustments for engines using J-Lash adjusting screws.

This is because of oil retained in the J-Lash adjusting screw. If unsure of the adjustment, repeat step1 and step 4. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-637