SERIES 60 SERVICE MANUAL thread the pilot into the tapped hole in the end of the installation/removal tool. See Figure 2-14. Figure 2-14 Removal of N2 Injector Tube 3. Tap on the end of the pilot using a brass hammer or fiber mallet. Using J–33880–4 and J–5286–5 (part of tool set J–33880) carefully drive and lift the injector tube from the cylinder head. If the injector tube O-ring is not removed with the injector tube, remove the O-ring from the cylinder head casting at the upper end of the injector tube bore. Discard O-ring. 2.4.3 N2 Injector Tube Crevice Volume Removal Tool Detroit Diesel has made a machining improvement on the Series 60 cylinder head injector tube bore.
This machining improvement removes cast iron material from the head at the crevice area, located just above the injector tube to cylinder head sealing land. See Figure 2-15 Figure 2-15 Crevice Area All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-29