2.4 N2 FUEL INJECTOR TUBE AND O-RING This process was implemented on new engines beginning with engine serial number 06R0656739. An injector nozzle seat cutter (J–45723) is now available to perform this machining process to engines built before engine serial number 06R656739. This tool includes two replacement bits. Additional bits (J–45723–1, part of tool set J–45723) are also available. See Figure 2-16. Figure 2-16 N2 Injector Nozzle Seat Cutter (J–45723) This procedure is required whenever the injector tubes are removed and only on engines built before engine serial number 06R0656739. 1. Apply cutting oil to cutting bit. 2.
Ensure injector tubes and O-rings are removed from injector bores. NOTE: Do not drop tool in bore, doing so would cause the cutting bit to chip. 3. Gently guide the injector nozzle seat cutter (J–45723) in injector tube bore taking caution not to score injector O-ring sealing surfaces. NOTE: Do not rotate tool in the counterclockwise direction as damage to the cutting bit will occur. 4. Using a speed handle and socket, turn cutter approximately 10 clockwise rotations at one turn every two seconds using moderate downward force. 5. Remove tool and inspect bit after each cut. If bit is chipped remove allan bolt and rotate bit 90 degrees.
Replacement bits (J–45723–1, part of tool set J–45723) are available. 6. Thoroughly flush metal shavings from injector tube bores. (Rev. 2005) All information subject to change without notice. 2-30 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION