SERIES 60 SERVICE MANUAL 2.44 PULSE WIDTH MODULATED STEPPER MOTOR VALVE (PSV) FOR SERIES 60G AUTOMOTIVE ENGINES A pulse width modulated stepper motor valve (PSV) is used to bias gas flow to the venturi mixer as a means of air fuel ratio control. The PSV is connected to the low pressure regulator through a special connector tube with two O-rings that seal against the inside diameter of the gas inlet port in the PSV. It is mounted to the mixer housing with four attaching bolts and uses an O-ring to seal the mounting flange. Gas flows through the PSV housing. The gas outlet passage in the PSV is intersected by a bore in which a piston operates.
Gas flow is controlled by precise positioning of the piston and the amount that the piston protrudes into the gas outlet passage. Greater protrusion into the gas passage increases restriction and results in reduced gas flow and a leaner air fuel ratio. Similarly, less protrusion reduces restriction resulting in higher gas flow and a richer are fuel mixture. The piston is driven by a stepper motor which positions the piston based on a (PWM) position command signal from DDEC. The PSV is electrically connected to the ECM and 12–volt battery power through a seven—pin connector that mates to the engine sensor harness.
The PSV supplies a "gas valve position" analog signal to DDEC which can be monitored using the diagnostic data reader (DDR). The signal indicates valve opening position and is scaled from 0 to 100 percent. A diagnostic signal is supplied to DDEC for loss of command signal, piston obstruction or valve electronics failure. See Figure 2-138. 1. PSV 5. Mixer 3. Washer 7. Connector Tube 2. Bolt 6. Connector O-rings 4. PSV O-ring Figure 2-138 Series 60G Automotive PSV 1998 and Later Engines All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-231