MACHINE OPERATIONS AND CONTROLS OPERATION WARMING-UP OPERATION NOTICE When the hydraulic oil is at a low temperature, do not carry out operations or move the levers suddenly. Always carry out the warm-up operation. This will help to extend the machine life. Do not suddenly accelerate the engine before the warm-up operation is completed. Do not run the engine at low or high idle continuously for more than 20 minutes. This will cause leakage of oil from the turbocharger oil supply piping. If it is neces- sary to run the engine at idle, apply a load from time to time or run the engine at a mid-range speed.
9JH02527A REMARK If the engine water temperature is above 30єC, to protect the turbocharger, the engine speed does not rise for 2 seconds after starting, even if the fuel control dial is turned. If the hydraulic oil temperature is low, the hydraulic oil temperature monitor display will be white. After starting the engine, do not immediately start operations. First, carry out the following operations and checks. 1. Turn fuel control dial (2) to the center position between LOW IDLING and HIGH IDLING and run the engine at medium speed for about 5 minutes with no load. Mid-range speed MIN low idling 2. Set safety lock lever (1) to the FREE position, and raise the bucket from the ground.
Free Lock 144