OPERATION Towing the Machine Serious injury or death could result if a disabled machine is towed incorrectly or if there is a mistake in the selection or inspection of the wire rope. Always check that the wire rope used for towing has ample strength for the weight of the machine being towed. Never use a wire rope which has cut strands (A), reduced diameter (B), or kinks (C). There is danger that the rope may break during the towing operation. Always wear leather gloves when handling wire rope. Never tow a machine on a slope. During the towing operation, never stand between the towing machine and the machine being towed.
Operate the machine slowly and be careful not to apply any sudden load to the wire rope. Remark The permissible pulling power of this machine is as follows. PC200: 142,000 N (14,600 kgf) Always carry out towing operations within the maximum towing capacity. If the machine sinks in mud and cannot get out under its own power, or if the drawbar pull of the excavator is being used to tow a heavy object, use a wire rope as shown in the diagram on the right. Place pieces of wood between wire ropes and body to prevent damage to ropes and body. Hold the wire rope level and direct it straight to the track frame.
When towing a machine, travel at a speed of less than 1 km/h for a distance of only a few meters to a place that is suitable for carrying out repairs. This is for use only in emergencies. PC200LC-8 2-197